FB Twitter Google Plus
My Basket:

Shopping Cart
Your basket is currently empty.


Click to view the full basket.
Search Site

change currency to dollars change currency to pounds sterling change currency to euros
view the basket

Kanda - Frequently Asked Questions


Here is the answer to the frequently asked question.





Popular Products


Handheld Programmers
handheld programmers

Simple to load and use, standalone battery powered Handheld Programmers for AVR, PIC and Serial EEPROM


Low Cost CANUSB
Low cost USB CAN Adapter picture

Lawicel CANUSB adapter for simple CANBUS connection to PC




Question:

When using ST7Starter kit, I receive the error message "No response from Device - Running Simulation" or "Unable to comunicate with Device"



Answer:
1) Check the Keys. Green key when using the programmer, blue key when simulating. They can be difficult to insert correctly. Push down along the top edge of the key as you insert it. After inserting the key, hold the board at eye level. Look along the top edge of the key socket - you should only just be able to see the tops of the keys' gold pads. Often 1mm or so can be seen - this is too much - the key is not inserted properly. If the key was inserted Ok, the key should spring out when the retaining clips are released.










      Product News       Special Offers       Sena Products       A-Z Product Index       Manufacturer Index       Software Downloads       Contact